You say all data is validated via MR with no issues outstanding. Did you run the diagnostic script found in the below KB article? If not, run that and if you get results then follow the steps in the article. https://mbs.microsoft.com/knowledgebase/KBDisplay.aspx?scid=kb;en-US;2931999 If you don’t get any results from this diagnostic script then in other cases I found the issue was with a blank CuryID somewhere which I would think the diagnostic script should find these but if it doesn’t then run the below scripts and verify the CuryID’s look correct. Run on application database select BaseCuryID, * from Ledger select CuryId, * from Currncy select BaseCuryId, * from GLSetup select * from GLTran where CuryId = '' select * from GLTran where BaseCuryID = '' select * from AcctHist where CuryId = '' select * from CuryAcct where BaseCuryID = '' select * from CuryAcct where CuryId = '' Run on system database select BaseCuryID, * from Company You could also go to the Configuration console and run the Run ERP data validation and then go to the Data Mart Integration logs and take a look at errors that may be there.
↧